No Products in the Cart
FEYNLAB® PLASTIC transforms faded dull exterior trim back into a deep rich looking finish. PLASTIC grants a new chemical structure which adds UV protection from future fading.
Once PLASTIC is Fully Cured, it is recommended to top with OVERCOAT for extra protection and hydrophobic.
Durability & Application Surfaces:
Durability – 1 yr.
Application includes 1 component layer.
APPROVED SURFACES FOR APPLICATION ONLY: – DO NOT apply to unapproved surfaces
Shelf Life:
Unopened – 1 year. Opened – Use within 3-4 months of opening. ALWAYS keep cap on bottle when not in use.
Included:
30ml (1oz) FEYNLAB® PLASTIC
Cautions:
Always wear respirator & gloves during application. Ensure application area is free of loose contamination.
Surface Preparation:
Thoroughly clean vehicle using FEYNLAB® PURE WASH vehicle to remove all topical contamination. Follow with a topical decontamination clay treatment using FEYNLAB® PRIME.
Directions:
Prior to application place vehicle in a well lit, temperature controlled 10°C-30°C (50°F-85°F), & contamination
free environment.
Shake PLASTIC vigorously for 1 min before use.
Application Instructions:
Multiple Coats: Allow application to cure for at least 12hrs (overnight) between additional coats.
Note: The amount of product required will vary based upon the overall composition of the plastic trim type and the starting condition. More oxidised faded trim may require more product for restoration. For extremely faded plastic use FEYNLAB®PLASTIC BLACK.
Final Inspection:
Be sure to carefully inspect all finished panels for any leftover coating residue (high spots) during the final wipe. Commonly edges, emblems, and other tight areas may contain some remaining residue. High spots are much easier to remove if caught within a 20-40 min window after the final wipe, than later when the coating has set and curing has started.
Post Application Instructions:
Climate Notes:
All FEYNLAB® Coatings are subject to different dwell and curing time windows due to humidity and temperature. In General, the higher the humidity level the quicker the coating will cure. If humidity level approaches 80% or higher than consider lessening the recommended dwell and wipe times for the coating.
If possible apply coating in temperature controlled environment 10°C-30°C (50°F-85°F), with humidity as low as possible.